(很急!)各位高手们,请教,灯具的slope(tilt) test

还是自己先顶一下吧,各位大侠建议一下吧!

至少通过6度的稳定性TEST

谢谢!大哥,你有没有EN60598-2-4,帮忙上传一个怎么样?

SORRY, I have not this standard.
but almsot the same with IEC 60598-1,
just another one important point you can remember:
the flex size at least 0.75mm2 but if the product is less than 1 kg and its current not exceed 2.5A, its flex length less than 2M can used 0.5mm2 size.

fist all, thank you very much!
I have read EN60598-1,I didn't find the slope(tilt) test requirements for general purpose portable floor or table luminiares,only the requirement for rough service luminiares was found in 60598-1. so what would you think of it? I respectly beg you response me, it is emergent. thanks!

It should be passed by 6 degree test at product its severe condition( it means the product should be assembled all parts together and at its severe condtion as possible as product can).
this requirement is not so strickt,as we always pass it at 10 degree or 15 degree slope test.
  you know household products mostly be required pass by 15 degree( IEC 60335-1)
   Hope this make sense to you.